When the stainless steel elbow processing, whether heating or cooling, they are not consistent because the cooling rate and the time of its surface and the formation of the temperature difference. This will cause the volume expansion and contraction caused stress, called thermal stress.
Stainless steel elbow
Stainless steel elbow under the action of thermal stress, the surface temperature will be lower than the heart, when the end of the cooling shrinkage, not free heart finally cooling, and the surface tension of heart compression. Under the action of thermal stress, the workpiece surface pressure and the heart of tension.
Thus causes this kind of phenomenon is due to the influence of cooling rate, material composition and heat treatment process.
Stainless steel elbow high frequency welding is the use of the alternating current trend skin effect and proximity effect, when the steel after rolling forming, forming a section break open the round tube blank, when the tube billet near the center of the induction coil near impedor, impedance and tube formed at the opening of an electromagnetic induction loop.
In the trend of the skin effect and proximity effect, blank opening edges will produce powerful and concentrated heat effect, and the edge of the weld is rapidly heated, reach the required welding temperature in the roll extrusion, the molten metal to achieve intergranular bonding, cooling after forming a firm butt weld.
Tuesday, January 4, 2022
Machining and high frequency welding of stainless steel elbow
Related Posts:
Getting the Best out of Stainless Steel By wilsonpipeline.comThe causes of disappointment can arise at any point in the long supply chain that often applies to a stainless steel project. This helps to explain wh… Read More
Stainless Steel Tubes and Copper Tubes in Heat Exchanger By wilsonpipeline.comThe high thermal conductivity of copper can not compensate poor thermal conductivity of organic solid black particles resulting in decrease of heat t… Read More
Selection 304 303 316 Types Stainless Steel for Seawater Application By wilsonpipeline.com316 types stainless steel are used widely in marine application, but their corrosion resistance in contact with seawater is limited and they cannot be… Read More
Salt Spray Testing of Stainless Steel By wilsonpipeline.comSalt spray testing is an accepted method for assessing the suitability of stainless steel parts and fabrications that are likely to encounter chloride… Read More
6 Of The Most Common Flange Types Used In The Oil And Gas Industry By wilsonpipeline.comUnderstanding joints, connections and the most common flange types used in the oil and gas industry is a core requirement to keep these levels of safe… Read More
Standard Reference for Seamless Steel Pipe
1. Seamless steel tube for structure (GB / T8162-1999) is a seamless steel pipe for general structure and mechanical structure. 2. Seamles...

0 comments:
Post a Comment